Search
Latest topics
» Video of BMW Disa Valve installationby Admin Fri Jul 19, 2013 5:45 pm
» Mercedes shifter selector repair Guide and Video
by 8thvision Tue Nov 13, 2012 2:11 pm
» 98-01 Toyota Corolla Improved Winshield Washer bottle
by 8thvision Tue Nov 13, 2012 1:49 pm
» 2001 Mercedes Benz W220 Strut
by Admin Mon Nov 12, 2012 6:51 pm
» BMW Disa Valve Installation Video
by Admin Thu Nov 08, 2012 4:58 pm
» BMW M42 and M44 Engines. Disa Valve.
by 8thvision Thu Nov 08, 2012 1:17 pm
» Benz E320 Headlight Wire broken
by kimchi Wed Oct 17, 2012 6:34 pm
» Rides & Styling
by 8thvision Mon Mar 12, 2012 1:06 pm
» Marlon Oakley Graphic Design
by 8thvision Thu Mar 08, 2012 2:28 pm
» Guest Book
by Guest Mon Feb 13, 2012 1:08 pm
Mercedes shifter selector repair Guide and Video
Page 1 of 1
Mercedes shifter selector repair Guide and Video
Removing the shifter assembly
Remove the shifter knob
Use a hammer or mallet to force the shifter to unlock
Remove the cover that sits directly under the shifter knob and unclip the electrical harness.
Remove the outer cover, this cover comes off with upward force this cover also has an electrical connector.
Remove the 2 front retaining crews for the center console.
Move both seats to their most forward position.
Remove the cover and retaining screw on both sides of the rear of the center console.
Gently Remove the air vent trim on the rear of the center console.
with the trim removed the air vent should freely come out. be sure to disconnect the electrical connector.
With access to the inside push out the bottom cover from the inside.
Pull out the wiring harness and disconnect all electrical connections, these are all important as they can be damaged when moving the center console if still connected.
Move both seats to their most rear position
The center console is ready to come off.
Lift the rear at about a 45 degree angle, with the ashtray flap held open begin to pull the console back with a little upward force, take care not to overly twist the console.
Move air vent up by forcing the front of each side up please note the vents do not need to be removed simply hold them in place once you have access to the shifter assembly
Undo the retaining bolts and unclip all wiring harnesses.
Disconnect the shift cable at the front by undoing the mechanism, do not pull or yank on this cable.
the assembly is held in place by a small notch on the bottom, use a light and maneuver the assembly it slides off of the notch freely.
Repairing the shifter assembly
8thvision- Admin
- Posts : 19
Join date : 2011-07-14
Similar topics
» 2001 Mercedes Benz W220 Strut
» How to Install: Altima / Quest Engine Mount (Installation Guide)
» How to install: Camry Outside/Inside Door Handle (Installation Guide)
» How to install: Maxima / I30 / I35 Seat Track Gear (Installation Guide)
» How to install: Maxima / I30 / I35 Seat Track Gear (Installation Guide)
» How to Install: Altima / Quest Engine Mount (Installation Guide)
» How to install: Camry Outside/Inside Door Handle (Installation Guide)
» How to install: Maxima / I30 / I35 Seat Track Gear (Installation Guide)
» How to install: Maxima / I30 / I35 Seat Track Gear (Installation Guide)
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum